German Caliper Decals for Porsche 911 Carrera Panamera Cayman GT2 GT3

ALL DECALS ARE MADE TO ORDER AND IS BRAND NEW USING PREMIUM VINYL FOR AUTOMOTIVE. ALL ORDERS PLACED WITHIN BUSINESS DAYS WILL RECEIVE TRACKING NUMBER WITHIN 24 HOURS!Since I used these myself, the best way to create the painted look for the "BRAND" logo on your calipers, use high temp clear to clear over the whole caliper once these decals are laid on. This creates an OEM finish on your calipers. Or you can run these decals on your calipers without clear as well. TWO DECALS: "H X 5"WTWO DECALS: "H X 4.5"WTWO DECALS: "H X 4"WTWO DECALS: "H X 3.5"WTWO DECALS: "H X 3"W**IMPORTANT**PLEASE MEASURE YOUR APPLICATION TO ENSURE THE SIZE YOU NEED. WE ARE NOT RESPONSIBLE IF THESE DECALS DO NOT FIT YOUR APPLICATION. CUSTOM SIZE IS AVAILABLE UPON REQUEST!Our Materials:We use only the best materials. Don't get tricked by the companies using cheap materials. The adhesive is made of a permanent solvent base polyacrylate (acrylic) which offers greater adhesive characteristics while still being able to remove the decal once it's no longer desired. The vinyl thickness ranges from 2-3 mils thick depending on the material. Application Instructions (if the decal has transfer film):1. Rub the sticker to be sure the transfer tape is properly adhered to the sticker.2. Clean and dry the desired area.3. Remove the paper backing slowly making sure the sticker stays adhered to the transparent transfer tape.4. Spray the area with 2% soap and 98% water.5. Carefully position the sticker to the desired area. The water will allow the vinyl to be re-positioned. 6. Use a squeegee/credit card and rub the sticker from one side to the other, eliminating any air bubbles and water that is trapped underneath. Continue until the adhesive adheres to the vehicles surface.7. Slowly remove the transfer tape, making sure no part of the sticker remains on the transfer tape.8. You may use blow dryer to soften the adhesive some more and rub the sticker so it will adhere better.9. Check for air bubbles. In most cases air bubbles can be worked to the edge of the sticker, but if not, a pin hole will allow the air out and become virtually invisible.10. Wrap the vinyl around the edges and use a blow dryer to dry off the remaining excess water.