PE50 Moonswatch Movement Holder Pack - Movement Holder Parts

PE50 moonswatch movement holder pack for conversion w/ metal case. These 4 holders vary in tolerances and fit to ensure you get a snug fit. There is also a spacer ring if needed (most cases won't need it for the PE50). These are printed with 100% infill to ensure that the feet don't break off when pressing in or removing as easily. I have tested this numerous times with no failures. Make sure to softly turn the backing until it seats onto the case with minimal resistance. If the backing isn't screwing in easily, don't force it. Back it out and slowly turn it until it slots into the threads (don't forget to insert the gasket). Screw on the case back snug (don't over tighten the case back) These are movement holders I resized after various iterations I created based off of "Caboose" on thingiverse. These fall under the Creative Commons License. If you have a 3D printer you can print them yourselves. However, they aren't a perfect fit if downloaded directly.(moonswatch metal case and internal movement not included) Only the movement holder ring pack