1-1/2" NPT 12VDC Plastic Zero Differential Electric Solenoid Valve Water Gas Air

Untitled Document td table img *Normally Closed – Opens when power is applied *Gravity Feed Capable – No Minimum Pressure Engineered Nylon Plastic12 Volt DC Solenoid Valve Function Normally Closed Connection 1-1/2” Inch FNPT Temperature Range 15 to 250° F Pressure Range 0 - 75 PSI (No Minimum) Power Requirements 40 Watts *Suitable Media Water – Air - Gas - *Etc Specifications Body

Material Engineered Nylon Plastic (PA66) Components Stainless Steel Seal

Material EPDM Operation Type Semi-Direct Lift Valve Coil Connection DIN 43650A Orifice Size 40 mm Cv Value Cv 30 (Appx 220 GPM @ 60 PSI) *Duty Cycle 100% but not indefinitely Weight 3 lbs 0.1 oz Height 6.70" Length 5.51" port to port Width 4.41 Connection – DIN Connector, DIN 43650A, with H Class - IP 65 - NEMA 4 enclosure rating. The valve is fast acting. Less than one second. Zero Differential Pressure is required. Mounting position is preferably coil up but can be mounted in any position. *Consult a chemical compatibility expert for correct seal and valve body material choice. *Duty Cycle – Like most solenoid valves the coil will become hot to the touch when left on continuously. The temperature will stabilize without failure. Leaving the valve powered on for long periods of time will reduce the life of the coil. Whenever possible the valve should be installed in a well ventilated are to increase the life of the coil. The valve is not intended to be left energized as a fail-safe for power outages. In this case please contact us for other options. A pre-filter is always recommended to keep the diaphragm free from debris and the valve functioning properly. Listing and template services provided by inkFrog