Insta360 GO 3 Screen Protector

High-definition and crystal-clear transparency. Strong tempered glass means full protection from bumps and scratches. 2.5D rounded edges for a smooth feel. Comes with a Protector Application Kit for easy at home installation. Screen Protector Flawless coverage, complete protection. Impact and scratch resistant. Go ahead. Bump it. Bang it. This high-strength tempered glass protector can take it. Like it was never even there. Provides 90% light transmission for a crystal clear display without affecting touchscreen sensitivity. Precision-engineered 2.5D rounded edges. Aligns perfectly with your GO 3 Action Pod for smooth, seamless swipes from edge to edge. In the Box 2x Screen Protector 1x Film Removal Stick 1x Protector Application Kit *Protector Application Kit contains: 2x Screen Cloth, 2x Dust Removal Sticker, 2x Screen Cleaning Wipe. Specs Size: 56.3x36mm (2.2x1.4in) Thickness: 0.37mm (0.01in) How to Use Installation Clean the screen: Clean the Action Pod screen using the screen cleaning wipe and screen cloth. Use the dust removal sticker to ensure the screen is clear from dirt. Apply screen protector: Remove the film from the screen protector. Position the screen protector over the screen. Slowly apply the protector until the screen is covered. Remove air bubbles: Scrape air bubbles from the middle of the screen outward, then press hard to both sides until air bubbles are completely removed. Remove the remaining film from the screen protector. *Notes: Do not reinstall the same screen protector. Any dust that has collected on the screen protector may cause air bubbles and reduce adhesiveness. If the screen protector moves during installation, use the film removal stick to remove the screen protector and repeat the steps above. Do not completely remove the installed screen protector.